New posts

Reply to thread

Message: [QUOTE="LaserMoose, post: 179212, member: 26991"] I don't own an Anbernic device, but you should find "Patch Codes" within the emulator's drop-down menu when you're booted into a game. It's near where you can Save State, Load State, Switch Discs, and Exit the game. Just scroll down and you should see it from there. Yes. I can give you what I sent as a .txt file in this message if that makes it easier on your end. Use the txt file instead of copying what I sent earlier, albeit their contents are identical. [ATTACH type="full" width="307px" alt="1745265506883.png"]60662[/ATTACH] Select "Add Patch" after selecting "Patch Codes". [ATTACH type="full" width="392px" alt="1745265590927.png"]60664[/ATTACH] Then select "Import from file" - there, select the file that I'm including in this message. Don't worry if you see this message, you just haven't enabled the codes yet:[ATTACH type="full" alt="1745265775189.png"]60667[/ATTACH] Go back to "Patch Codes", and press "Edit Codes" to check that the codes were imported correctly, then you can press "Enable Codes", which should apply the patch to the game. I'd reset after enabling to see if it shows a level select of some sort. Again, I haven't tested the code, so I do apologize if it doesn't come up in some way. Codes won't do anything to your system. Worst case scenario, the game might crash with the codes enabled. To disable the codes, you disable them the same way you enable them. Yep, the USA rom is what I meant by NTSC. Europe is usually referred to as the PAL version of a game. [/QUOTE]

Verification

Online statistics

Members online: 149

Guests online: 3,749

Total visitors: 3,898

Totals may include hidden visitors.

Forum statistics

Threads: 13,084

Messages: 318,394

Members: 873,602

Latest member: soditadefresq

Reply to thread

Online statistics

Forum statistics

Advertisers